Wilson Electronics 304453 Datasheet download pdf (Page 8)

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660

or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.

Outside Antenna Installation

The antenna should be mounted as shown in the illustration above.

The mounting bracket, included with antenna, is adjustable and will

accommodate pipe diameters from 1.25” to 2” (pipe sold separately

#901117). Mount the antenna so that there is at least 3 feet of clearance

in all directions around it. Position the antenna so that it has an

unobstructed line of sight to the cell tower’s strongest signal. Make sure

the antenna is not pointing across your own roof or at the Inside Antenna

as this will cause the oscillation protection circuitry to shut down the

Signal Booster.

Warning:

Lightning protection is recommended for all installations

(#859902-50 Ohm shown below). Take extreme care to ensure

that neither you nor the antenna comes near any electric power lines.

Installing Lightning Protection (sold separately)

Install the Lightning Surge

Protector (LSP) close to the Signal

Booster. Attach the cable from

the Outside Antenna to the surge

protector, using a short length of

low loss cable; attach one end

to the LSP and the other to the

Outside Antenna connector on the

Signal Booster. Ensure the LSP is

properly grounded (ground wire not

included). LSP sold separately, go

to www.WilsonElectronics.com or

call 800-204-4104 to order.

(not included)

Lightning

Surge Protector

(sold separately)

Signal Booster

Surge Protector Power Strip

Ground Wire

(not included)

To Outside

Antenna

To Signal

Booster

To Inside

Antenna

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Wilson Electronics 304453 Datasheet Page 8

Comments to this Manuals

Related products and manuals for Cellular wireless network equipment Wilson Electronics 304453