Wilson Electronics 304453 Datasheet download pdf (Page 3)

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660

or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.

Select a location to install the Signal Booster that is away from 1.

excessive heat, direct sunlight, moisture and has proper ventilation. Do

not place the Signal Booster in an air-tight enclosure.

Select a location on the roof of the building to install the Outside Antenna. 2.

Use a cell phone in test mode to find the strongest signal from the cell tower.

Refer to page 7. Visit

www.WilsonElectronics.com

to find the test mode

function for your particular cell phone.

Run the Outside Antenna cable to the Signal Booster and attach it to the 3.

connector labeled “Outside Antenna” on the Signal Booster. Refer to page

8 for more information on running cable. Lightning Surge Protection is

recommended for all in-building installations refer to page 6.

Select a location for the Inside Antenna, preferably in the center of 4.

where the signal needs to be amplified. A minimum separation distance

of 20 vertical feet (within the null zone) or 50 horizontal feet is

necessary for proper operation. If the inside coverage is not sufficient

you may need as much as 75 feet of horizontal separation (refer to

installation diagram on pages 3 & 4).

Run the Inside Antenna cable to the

Signal Booster and attach it to the connector labeled “Inside Antenna” on

the Signal Booster.

Before powering up the Signal Booster, verify that both the Outside 5.

Antenna and the Inside Antenna are connected and check that all

connections are tight. Refer to page 9. Note: Be careful when plugging

the connectors in so as not to bend the center pins on the connectors.

If lights are not green, please refer to pages 13 & 14.6.

Quick Install Overview

See Installation Diagram on page 3 & 4. Contact Wilson Electronics

Technical Support Team with any questions at 866-294-1660.

Warning: Connecting the Signal Booster directly to a cell phone with

use of an adapter will damage the cell phone and/or the

Signal Booster.

IMPORTANT NOTICE

It is very important to power your Signal Booster using a •

surge protected AC Power Strip with at least a 1000 Joule

rating.

Failure to do this will void your warranty in the • event of a

power surge or lightning strike.

1 2 3 4 5 6 7 8 ... 15 16

No comments

Wilson Electronics 304453 Datasheet Page 3