Wilson Electronics 304453 Datasheet download pdf (Page 11)

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660

or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.

Signal Booster

Outdoor

Panel

Antenna

Outdoor

Panel

Antenna

Inside Panel

Antenna

Figure 1

Figure 2

CORRECT INSTALLATION

Never point antennas toward each other

Powering up a Wilson Electronics

Signal Booster

1. Never point the front of a directional Outside Antenna toward the

Inside Antenna. See Figures 1 & 2 above.

2. Ensure that both the Outside Antenna cable and the Inside Antenna

cable are connected to the Signal Booster and the connections are

tight before powering up the Signal Booster.

3. Plug the power supply into the Signal Booster input marked “Power”

(carefully, to avoid damaging the center pin) and then into a surge

protected AC Power Strip.

4. If the Signal Booster does not have green lights, please refer to

pages 13-14.

5. Using multiple Signal Boosters in one installation could cause

interference to the cell tower.

Contact Wilson Electronics Technical Support Team with any questions

at 866-294-1660 or email [email protected]. Technical

Support hours are Mon.- Fri. 7 am to 6 pm MST.

During installation mode the Signal Booster is resetting itself very quickly

to aid the installer. The Signal Booster is equipped with one indicator

light. For the first 15 minutes that the Signal Booster is plugged in, it is

programed for a test and alignment period.

Point antennas away from each other

INCORRECT INSTALLATION

Inside Panel

Antenna

Signal Booster

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

Wilson Electronics 304453 Datasheet Page 11