Wilson Electronics 304453 Datasheet download pdf (Page 7)

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660

or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.

Panel Antenna

Mount the Outside Antenna as high as possible facing the cell tower in

an area with the best possible signal coverage.

Note:

Never point the front of a directional antenna toward the Inside

Antenna. See Figures 1 & 2 on page 10.

Finding the Strongest Signal

When installing your Signal Booster’s Outside Antenna, aiming it towards

the best signal source from you service provider is important. The

best way of getting the strongest signal is to have one person on the

roof to rotate the Outside Antenna, which is connected to the Signal

Booster. Turnt the Outside Antenna about 45 degrees at a time, while the

second person is watching the signal strength on the phone inside the

building. This allows you to read the signal strength from the cell tower.

It is preferable to have the phone in the test mode so the actual signal

strength can be read, as bars are not the most accurate. Go to

www.WilsonElectronics.com for help in finding the test mode for your

phone. Always make sure the person inside the building gives the signal

time to arrive and register on the phone (between 10-30 seconds for

phone to reset to the signal reading).

-50dB -60dB -70dB -80dB -90dB -100dB -110dB

EXCELLENT GOOD POOR NO

SIGNAL

Signal Strength Graph

Cell Tower

Cell Signal

Outside

Panel

Antenna

Signal readings usually appear as a negative number (for example, -86).

The closer you get to zero the stronger the signal. (See graph below).

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

No comments

Wilson Electronics 304453 Datasheet Page 7