Wilson Electronics 801241 Datasheet download pdf (Page 10)

Warnings and Recommendations

Warning: Do not plug the ampliﬁ er directly into the cell phone or cellular

data card using an antenna adapter. It will damage the cell

phone or cellular data card.

Warning: Do not plug in the DC power supply until the outside antenna

cable is attached to the ampliﬁ er.

Warning: RF Safety: The ampliﬁ er with its built-in antenna must be

installed with a separation of at least 8 inches from all persons

and must not be located in conjunction with any other antenna or

ampliﬁ er.

Warning: RF Safety: The outside antenna must be installed with a

separation of at least 8 inches from any of the vehicle’s

occupants or nearby persons and must not be located or

operating in conjunction with any other antenna or ampliﬁ er. All

roof-mount antennas should be centrally located on the roof of

the vehicle. Use of this cellular ampliﬁ er with an antenna gain

higher than 6.12 dBi is in violation of FCC regulations for which

the offender is fully liable. All Wilson mobile antennas are 6.12

dBi or less.

Separation of inside and outside antennas is very important. In a vehicle,

the metal roof acts as a barrier and helps shield the two antennas from

each other, preventing oscillation.

If the vehicle has a sunroof, it is important to keep the outside antenna at least 12

inches from the edge of the sunroof. This prevents the ampliﬁ er from overloading or

oscillating.

1 2 ... 5 6 7 8 9 10 11 12

No comments

Wilson Electronics 801241 Datasheet Page 10